Products can be used in homes, farms, factories, offices, laboratories, supermarkets and so on
Remote control Water pump \ Fan \ Lamp \ LED light \ bulb \ ventilation device\ Exhaust system,Kettle,water heaters \ Signal transmission \ Electrical equipment
Remote controller
-- Control Distance :up to 50m (theoretical distance)
--RF frequency : 433MHz
--Support encoding : 1527 Leaning code
--Battery : 2 X CR2016 3V Lithium Battery ( include )
Technical Data Of Receiver
--Input Power:AC 85V-250V
--Max current: 30 A
--RF Frequency: 433Mhz
--Working temperature:-30~+80
--RF working mode:superheterodyne
--Receive sensitivity: >97dbm
--Transmitting distance: up to 50m (theoretical distance)
--Remote storage:25pcs
--Support remote type: Learning code 1527code, Fixed code
--Working mode:Momentary, Toggle, Latching mode
--Dimension :65*58*30(mm)
--Weight:66g
Instructions:
1.Jog: The remote control is controlled by a button.After pressing the button, the relay is closed, and when the button is released, the relay is disconnected.
2.Self-locking: The remote control is controlled by a button.Press the button once to pull in the relay, and press it again to disconnect.
3.Interlock: The remote control is controlled by two buttons.Press the A button to close the relay, and press the B button to disconnect.
Learn to code:
1. Jog learning method:Press the learning button of the controller once, the indicator light flashes quickly and it is in the learning state, and then press any button of the remote control you want to learn to send a code. At this time, the indicator light flashes three times and goes out, and the code matching is completed.
2. Self-locking learning method:Press the controller learning button twice, the indicator light flashes twice quickly in the learning state, and then press any button you want to learn on the remote control to send a code. At this time, the indicator light flashes three times and goes out, and the code matching is completed.
3. Interlocking learning method:Press the controller learning button three times, the indicator light flashes three times quickly in the learning state, at this time press the remote control A button, the indicator light flashes three times, and then press the remote control B button again, the indicator flashes three times and goes out, and the code matching is completed .
Clear data:Press and hold the learning button for 8 seconds without letting go, the indicator light flashes once until the receiver indicator flashes 6 times quickly, the code clearing is successful
pacote inclued:
A:
1 x Transmitter(with battery)
B:
1 x Receiver(with cover)
C:
1 x Receiver(with cover)
1 x Transmitter(with battery)
D:
1 x Receiver(with cover)
2 x Transmitter(with battery)
E:
1 x Receiver(with cover)
3 x Transmitter(with battery)
F:
1 x Receiver(with cover)
4 x Transmitter(with battery)
